at Hartbeespoortdam  74 Scott str, tel 012 2531396

Gemstone beaded jewellery

Create your own design-

Before threading a single bead, choose the best pattern and kind of beads you need. Create a beautiful design. If you don't have a beading board, use a small terry-cloth towel to keep the beads from rolling away. After laying out the pattern, make any final changes or adjustments.</P>

Attach half of the jewelry clasp - 

Tie one half of the clasp onto the end of the beading thread. A regular double or triple knot will do. After tying the knot, put a small dot of glue or clear fingernail polish on the knot. Once the glue or nail polish has dried, use beading scissors or nail clippers to cut off the loose end as close to the knot as possible.</P>

Thread the beads -

Slide all of the gemstone beads that you set out in a pattern as above onto the beading thread using the attached needle. Once all the beads are on the thread, hold the strand up with the clasp that is already attached at the bottom. Let the beads naturally fall against each other so there are no gaps between them.</P>

Connect the other half of the buckle-

This is the hardest part of making gemstone jewelry. The thread must be pulled the knot tight and snug against the last bead to avoid any gaps. To do this, slide the clip to the thread and make a very loose knot at the base of the buckle. Put the bead knotting tool or a large pin through the center of the knot loose. Not tighten the knot carefully the work of the node to the heel so that the knotting tool or pin is comfortable against the last bead.

Lift the thread up and make sure that there are gaps. Pull the thread tight to the beads, but don't allow the knot to tighten again. Without releasing the tension on the wire through the beads, lay the thread down and start to tighten the knot while maintaining pin comfortable against the last bead. (This process is similar to tie a knot on a package with a finger to keep the knot tight. In this case, the pin is serving the same purpose as the finger on the package.) Continue pulling the thread until the knot is tight without gaps. Gently remove the pin or push the issue on the bead knotting tool. Place a small dot of glue or clear nail polish on the node. After the glue or nail polish is dry, use scissors or nail clippers to cut the beading free end close to the knot as possible.

 Have you ever made Jewelry with Gemstone Beads? You may have seen various kinds of jewelry like handmade jewelry, gold, silver jewelry, metal, diamond jewelry, fashion jewelry, body jewelry, sterling silver and gemstone jewelry. But have u ever thought that how can u make your own jewelry using gemstone beads like semi precious beads and precious beads.

You can make beautiful earrings, necklaces, bracelets, rings, pendants and many more to gift your loved once. You can also wear on various occasions and daily life as well. Natural Gemstone beads are long lasting and look beautiful.

You can create a different jewelry piece, or two, to go with every outfit. Making gemstone jewelry isn't difficult, and designing each piece can be a lot of fun. You can check out our gemstone jewellery at THE SILVER HILLS GEMSTONE page